1
PELLET STOVE HEATER
Model: SIP-S1500M
INSTRUCTION MANUAL
IMpORTANT:
REAd THiS mAnuAL cAREfuLLy TO LEARn HOw TO ASSEmBLE,
OPERATE And mAinTAin yOuR PROducT PROPERLy. iT iS ESSEnTiAL
THAT yOu OR Any OTHER OPERATOR Of THE APPLiAncE REAd And
undERSTAnd THE cOnTEnTS Of THiS mAnuAL BEfORE OPERATing.
THE infORmATiOn in THiS mAnuAL cAn HELP yOu And OTHERS
AVOid injuRy And PROducT dAmAgE. fAiLuRE TO fOLLOw ALL
inSTRucTiOnS cOuLd RESuLT in PROPERTy dAmAgE, BOdiLy injuRy
OR EVEn dEATH.
STORE THiS mAnuAL in A SAfE PLAcE fOR fuTuRE REfEREncE.
THE PELLET STOVE muST BE inSTALLEd By PROfESSiOnAL OR
cERTifiEd PERSOnnEL. iT REquiRES VEnTing in AccORdAncE
wiTH LOcAL cOdES And fiRE REguLATiOnS. cOnTAcT yOuR LOcAL
BuiLding OR fiRE OfficALS fOR RESTRicTiOnS And inSTALLiOn
inSPEcTiOn REquiREmEnTS (incuLding PERmiTS) in yOuR AREA.
EAcH uniT HAS BEEn TESTEd BEfORE LEAVing THE fAcTORy SO THERE
mAy BE LiTTLE RESiduE Of ASHES OR PELLETS inSidE.
This manual identifies potential hazards and has special safety messages that help
you and others avoid personal injury and even death. Danger, Warning, and Cau-
tion are signal words used to identify the level of hazard.
wARning SignALS A HAzARd THAT mAy cAuSE SERiOuS
injuRy OR dEATH if yOu dO nOT fOLLOw THE REcOmmEndEd
PREcAuTiOnS.
cAuTiOn SignALS A HAzARd THAT mAy cAuSE minOR OR
mOdERATE injuRy if yOu dO nOT fOLLOw THE REcOmmEndEd
PREcAuTiOnS.
However, regardless of the hazard, be extremely careful.
CAUTION:
IMpORTANT SAFETY INSTRUCTIONS
If you have any problems with this unit or there are missing or damaged parts,
please call our Customer Service line toll free at 1-800-459-4409. DO NOT RETURN
THE UNIT TO THE PLACE OF PURCHASE before calling the toll free number above.
We recommend the use of smoke detectors and carbon monoxide detectors with
this type of product. Follow the manufacturer’s instructions when using smoke or
carbon monoxide detectors.
wARning - do not Touch the fireplace while it is burning. Allow
at least 15 minutes to cool down after the flame is extinguished for any
refill/ restart/cleaning/maintenance.
wARning - do not operate unit with hopper open.
wARning - Lid must be shut and tightly secured.
wARning - do not Operate with door Open.
wARning - dO nOT TOucH THE uniT wHiLE OPERATing AS iT iS
HOT. mAy cAuSE BuRn HAzARd.
wARning - KEEP cHiLdREn And AnimALS AwAy fROm THE
fiREPLAcE.
wARning - dO nOT STORE / PLAcE fLAmmABLE gOOdS cLOSE TO
fiREPLAcE.
wARning - RESTRicT THE uSE Of THiS PROducT TO PERSOnS
wHO REAd, undERSTAnd And fOLLOw THE wARningS And
inSTRucTiOnS in THiS mAnuAL And On THE uniT.
1) Check local installation codes for your area. Call your Homeowner’s Insurance
representative for inspection of your stove’s installation.
2) Read and comply with the instructions in this manual.
3) This stove is designed to burn Premium Wood Pellets only. Burning pea coal,
cherry pits or anything other than wood pellets will void your warranty. Pel-
lets with high ash content will not burn clean and will require the unit to be
cleaned more often. This unit is designed for use with 6mm (1/4 in) diameter
pellet fuel. Using pellets longer than 50 mm (2 in) can bind the auger and
require frequent manual removal.
4) Be sure your pellets are not damp or wet. Keep sawdust out of the unit.
5) Use 76mm (3 in) UL approved Pellet Vent Twist-Lock Pipe when installing
this stove and follow the manufacturer’s specifications for installation and
clearances. Even though this pipe interlocks, it is recommended to seal all con-
nections with high temperature silicone. Use at least three screws to secure
the pipe to this unit’s exhaust blower. If you do not use UL approved twist-lock
pellet pipe, be sure to use UL approved pellet vent pipe and fasten each joint
with at least three screws.
6) Outside combustion air is mandatory for this unit to work properly. Make this
connection using 48mm (1- 7/8 in) ID metal pipe and coupler. Be sure to
secure the pipe to the unit with a clamp. The outside end should be covered
(screened) to prevent any foreign matter from entering the system. Try to
keep the number of bends in this pipe to a minimum.
7) Regularly inspect the burn pot area and if any crust forms, remove it with a
poker.
8) The ash in the burn pot should be removed regularly depending on the burn
rate. Keep the air holes of the burn pot clean for a more efficient burning.
Check your exhaust system frequently.
9) Keep pellets and all other combustible materials at a safe distance from
the unit.
10) This unit requires floor protection if installed on a combustible surface. The
minimum floor protection should give at least 152mm (6 in) of protection at
the rear, and 101 mm (4 in) on each sides and 152mm (6 in) minimum at the
front of the unit.
SYL
VAN
IA is a registered tr
ademark of OS
RAM SYL
VAN
IA, used under license.
Содержание SIP-S1500M
Страница 9: ...9...
