41
Alerting „Fault message“
Run. No. Basic settings „Alert function“
Page
1
4.5.1 Switching on the alert function (factory pre-set:
switched on)
17
2
4.5.2 Determining and storing alert call numbers
18
3
4.5.3 Setting alert parameters
19
After this, program and test the fault message call:
Run. No.
Setting and testing the alerting „Fault message call“
Page
4
8.3.1 Assigning alert call number(s)
41
5
8.3.2 Listening fault announcement
42
6
8.3.3 Testing the fault message call
42
8.3.1 Assigning alert call number(s)
Assign the desired alert call-number(s) to the call trigger „Fault message
call“.
ATTENTION
In the following procedure it is not the call number itself
which is allocated but instead the memory location in which
the number is stored (see table on the page 18).
Example: If you want to assign the number 4 and 5, so
enter 45. If a fault message call is triggered, the numbers
are dialled chosen in order of entries.
Open
Menu
> press
to select „Menu release PIN“
>
Ok
.
Enter 4-digit PIN >
Ok >
„Alerts“ >
Ok
.
Press
to select „Call trigger“ >
Ok
.
Press
to select „Fault message“ >
Ok
.
Enter assignment (memory location(s) of the call num-
ber(s)) for example, 45 for the call numbers of the locations
4 and 5 >
Ok
.
Select further settings or press and hold
Back
to return to
standby mode.
