© 29DEC19 SyberSense
1 / 6
DOC ID – 1706 • Rev 01
Description
Important safety instructions–
Before you install this sensor, be sure to:
Read, keep, and follow all instructions.
Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
When there is a low battery, replace with a compatible
lithium ion battery.
Installation
Note:
We recommend adding the motion sensor to a panel
before installation. Step 4 shows how to pair with a panel.
The motion sensor can be installed using the provided
adhesive and/or screws.
Note:
We recommend using the provided screws for
installation. This method is more secure than using adhesive
alone.
To install the motion sensor:
1. Select the desired position for the sensor.
Note:
The sensor only detects motion within 3.28 ft (1m)
in front of it (installed at 6.88 ft (2.1m) having a range of
32.80 ft (10m).
2. Remove the sensor’s battery pull tab.
3. Adhere the sensor to the wall using the provided screws or
adhesive.
Note:
We recommend using the provided screws for
installation. This method is more secure than using
adhesive alone.
Screws
a. Locate the bottom of the sensor (the slotted flat
end), and then use a screwdriver to remove the
casing’s screw.
b. Gently
slide
a
fingernail/fingertip
into
the
slot
and
push
the
top
casing
of
the
sensor
upward.
XPM03
Motion Sensor Manual
The XPM03
is designed to fit seamlessly in the corner or the
room or alongside a wall/door. When the PIR senses motion it
transmits an alarm notification to the panel.
Part number:
XPM03-E-1433
