Which information is necessary?
4-2
4.1.1.1
New LAN—fully automatic configuration possible
If all connected network devices are still unconfigured, the setup
wizard will suggest fully automatic TCP/IP configuration. This may
be the case in the following situations:
• a single PC is connected to the router
• setup of a new network
Fully automatic TCP/IP configuration will not be available when
integrating the SwyxConnect in an existing TCP/IP LAN. In this
case, continue with the section ’Information required for manual
TCP/IP configuration’.
The result of the fully automatic TCP/IP configuration: the router will
be assigned the IP address '172.23.56.1' (netmask '255.255.255.0'). In
addition, the integrated DHCP server will be enabled so that the
SwyxConnect can automatically assign IP addresses to the devices in
the LAN.
4.1.1.2 Configure manually nevertheless?
The fully automatic TCP/IP configuration is optional. You may also
select manual configuration instead. Make your selection after the
following considerations:
• Choose automatic configuration if you are
not
familiar with
networks and IP addresses.
• Select manual TCP/IP configuration if you are familiar with
networks and IP addresses, and one of the following conditions
is applicable:
• You have not yet used IP addresses in your network but
would like to do so now. You would like to specify the IP
address for your router, selecting it from the address range
reserved for private use, e.g. '10.0.0.1' with the netmask
'255.255.255.0'. At the same time you will set the address
range that the DHCP server uses for the other devices in the
network (provided that the DHCP server is switched on).
• You have previously used IP addresses for the computers in
your LAN.
4.1.1.3
Information required for manual TCP/IP configuration
During manual TCP/IP configuration, the setup wizard will prompt
you for the following information:
Содержание SwyxConnect 1722
Страница 112: ...I 5 ...
