14
Copyright © 2003, 2004, 2005 by swl-remotes.com,
All rights reserved.
Configuration Parameters
0 9 1 Enter
Set CI-V address
x x Enter
CI-V address set to xx
or
x Mute y Enter
y converted to hex (e.g. 1 – A, 2 – B, etc)
5A would be entered as:
5 Mute 1 Enter
0 9 2 Enter
Set Radio Port baud rate
1 9 Enter
19200 Baud
(Factory Default)
9 6 Enter
9600 Baud
4 8 Enter
4800 Baud
1 2 Enter
1200 Baud
0 9 4 Enter
Set Frequency Pacing
x x Enter
Value from 1 to 99 to control pacing. 1 is the fastest and
99 is the slowest.
0 9 5 Enter
Set Configuration Parameters to Factory Defaults.
Enter
Reset Configuration Parameters to Factory Default.
CI-V
5A
Radio Baud
19200 baud
Frequency Pacing
30
Optional Modes/AGC Disabled
0 9 6 Enter
Enable/Disable Optional Mode Selections
0 Enter
Disable FM and CW modes in selections.
(Factory default)
1 Enter
Enable FM mode in selections.
2 Enter
Enable CW mode in selections.
3 Enter
Enable both FM and CW in mode selections.
4 Enter
Disable AGC off (Factory default).
5 Enter
Enable AGC off in AGC selections.
0 9 7 Enter
Define User Tuning Steps
x Mute f f f f Enter
The User Tuning step x (1, 2, 3, 4, or 5) is defined as frequency
ffff
,
converted to f.fffkHz. You must enter all digits, even zeroes; e.g. define
Tuning Step 2 with a value of 1.4kHz would be
2 Mute 1 4 0 0 Enter
.
The display on the radio will show the value as 2.140.000Hz when you
are done to confirm the entered value. It is best to set these tuning steps
with the receiver on and in the VFO mode. These steps are saved in non-
volatile memory and are never changed except using this configuration
mode.
0 9 8 Enter
Define User Analog Control Settings
x x Mute a a a Enter
The User Analog Control xx is defined as
aaa
. The value of
aaa
must be
between 0 and 255. You must enter all digits, even zeroes; e.g. define
RF Gain User Defined analog setting 6 with a value of 220 would be
1 8
Mute 2 2 0 Enter
. The display on the radio will show the value as