Pg. 21
Running Display
This menu control running parameters
RPM ACC
– Press “OK” to access
acceleration curve
Max RPM
– Set maximum RPM
Idle
– set idle RPM
Min RPM
– set stop RPM - if motor RPM
falls below this setting, motor will
shutdown.
MaxTemp
- Set maximum running temp.
If motor exceeds this value, ECU will
automatically limit fuel in order to
reduce the temp.
LowVolt
– set low volt warning
Restart
- Can be set “valid” for enable or
“invalid”
disabled,
flame
out
automatically restart or not
Restart power pump
– set power to pump
on restart. Normal range from 0.5 – 1.1
Volt
RPM Acceleration Curve/Delay time
Set FULL (high speed)
- The ECU will
automatically calculate the response of
IDLE the acceleration rate of value (low
speed). Adjust according to weather,
Altitude (ASL) or other conditions which
require adjustments to delay time. It is
best to select a value that is lower than a
setting that yields the fastest possible
response time in order to avoid a flame
out.
Raise value to decrease response time
Lower value to increase response
time.
Note: The performance of the motor in
the
air
might
be
different
than
performance while on the ground. Be
