Head Pad Styles Offered
Adult with Swing Away Facial Pads
(P/N: DP-A)
Pediatric with Swing Away Facial Pads
(P/N: DP-P)
Adult with Hinged Pads
(P/N: DP-3-A)
Pediatric with Hinged Pads
(P/N: DP-3-P)
Programming Interface Examples
1. 40% speed within proximity (crawl) and light
force for full speed.
2. Light Force on pad for full speed, no
proximity (crawl) speed.
3. Fully proximity switched head array.
4. 60% speed within Proximity (crawl) switch
and the reach full speed with medium force.
Detailed Example
The Dual Pro will send a signal to the chair as a
percentage of full speed. For instance, if the
chair is set to 100% forward speed and the
proximity (crawl) switch is set to 20% then the
chair will only move at 20% of full speed in the
proximity (crawl) mode. When pressure is
applied to the force sensor, the percentage will
increase until the maximum rate is met. If the
force is set to 80%, the maximum speed will be
80% of the chair settings. Be aware that if the
chair is set to 50% maximum speed, the
percentages will drop accordingly. A 20%
setting of the switch in the Dual Pro will result in
10% of maximum speed(20% sent by head array
to a chair setting of 50% will equate to 10% of
maximum drive).
It is recommended that the chair be set at 100%
and the percentages be adjusted through the
Dual Pro profile functions.
Compatibility
Penny and Giles R-Net – Omni is required
Curtis Electronics Enable 50 – Enhanced Display
is required
Dynamic Controls DX2 – Switch It DX Dongle
(DXD) is required
WARRANTY -1 year from the date of
manufacture
DISCLAIMER Avoid use under power lines and around
cellular phones.
Caution should be exercised with regards to the use of
portable communications equipment in the area around
where the sensors are located in the head array. If the
wheelchair behaves erratically, shut the wheelchair off
immediately and contact the dealer.
Ensure wheelchair is powered off when in a vehicle or during a
patient transfer.
Ensure wheelchair is powered off when plugging or
unplugging switches or sensor on the back pad.
This product is not to be used in the rain or in an environment
where moisture could build on the pads.
Doc: 09.2015 –DP-IGRevA