S-8U63 Rechargeable Li-ion Battery Pack
Tel: +86-25-85805753
Fax: +86-25-85805296
http://www.swit.cc
E-mail: [email protected]
Characteristics
1. The battery pack is compatible with SONY PMW-EX1/3, F3,
PMW-100/200 and PXW-FS7, X180/200 series cameras;
2, Display remaining power info in camera viewfinder;
3. 4-step LED power indicators;
4. D-tap DC output socket;
5. 5V/1A USB DC output socket for cell phone charging;
6. Build-in multiple protective circuit design.
Caution
1. The battery pack is not fully charged when it is purchased.
Charge the battery before use.
2. Use SWIT charger or the chargers recommended by SWIT.
3. Never attempt to open the battery pack.
4. Keep the battery pack terminals clean.
5. Never short-circuit the battery pack terminals.
6. Never expose the battery pack to rain, fire or moisture.
7. Never expose the battery pack to temperature above 60°C.
8. Avoid strong mechanical shock.
9. The battery pack may become warm in use or while being
charged. This is normal.
10. Fully charged battery pack will discharge naturally and please
use it as soon as it gets charged.
11. At low temperature, the running time of battery pack usually
decreases.
12. The internal impedance of battery pack will be greater at low
temperature, which may cause the automatically circuit cutting.
Charging
The battery pack can be charged by SWIT S-3602U or SONY
BC-U1 charger via bottom terminals, or charged by SWIT
portable charger S-3010B via D-tap DC socket.
The battery pack should be charged within a temperature range
of 0-40°C
LED indicator
1. The four-step LEDs indicate the remaining capacity when
press the power check button.
2. The indicator may not be accurate when the battery is
powering on the camera.
3. When only one LED indicates, please charge the battery as
soon as possible.
Power check button
D-tap DC socket
The D-tap DC socket can be used as 14.4V DC output or SWIT
S-3010B charging input.
1. Open the rubber cover and plug in D-tap lead to DC output or
charge.
2. Close the rubber cover when disconnected, to keep the socket
away from dust.
14.4V D-tap DC output
Or S-3010B charging input
USB power output
The battery offers a 5V/1A USB power output socket, for
charging cell phones.
1. Open the rubber cover and plug in USB lead;
2. Connect with the device to be charged;
3. Press the power check button to switch on the USB charging
4. When USB charging finished, close the rubber cover to keep
the socket away from dust.
5V/1A USB output socket
Specifications
Model
S-8U63
Nominal Voltage
14.4V
Capacity
63Wh, 4400mAh
Max
Output
Pins
50W, 3.5A
D-TAP
50W, 3.5A
USB
5W (5V / 1A)
Total
50W, 3.5A
Compatible Cameras
SONY PMW-EX1/1R/3, F3
SONY PMW-100/200
SONY PXW-FS7/X180/X200
Dimension
41.5×69.6×96.1mm
Net weight
403g
Ver:V1.0.1V00
