![Swisscom Top E604 ISDN Скачать руководство пользователя страница 101](http://html1.mh-extra.com/html/swisscom/top-e604-isdn/top-e604-isdn_user-manual_1415095101.webp)
99
System settings
CX 253i / SWZ PTT en / A31008-X353-P100-1-19 / settings_bs.fm / 03.12.2007
Activating/deactivating internal call diversion
Requirement:
Internal call diversion can only be activated if a destination has been set
up.
Defining the number of rings
When ring delay is used, the number of rings before the call is diverted must be defined.
Between 0 (= immediate call diversion) and 9 rings can be set. There are 5 seconds
between rings.
The factory default setting is 0 rings (= immediate call diversion).
Diverting calls externally – CF (Call Forwarding)
For each receive MSN you can store a destination number for each of the following
conditions:
Immediately
–
On busy
–
On no reply
Set up external call diverts are entered in a list. Active call diverts are identified in this
list.
When the phone is supplied external call divert is not set.
i
Open the menu.
s
Set base
Select the menu item and confirm.
s
Int. call forw.
Select the menu item and confirm.
~
Enter system PIN if required (page 89).
either ...
Activate:
Activate?
Confirm.
or ...
Deactivate:
Deactivate?
Confirm.
OK
OK
OK
OK
OK
i
Open the menu.
s
Set base
Select the menu item and confirm.
s
Forward. base
Select the menu item and confirm.
~
Enter system PIN if required (page 89).
s
No. of rings
Select the menu item and confirm.
~
Enter the number of rings and confirm.
j
Hold
down (back to idle status).
OK
OK
OK
OK
OK
i
◆
If call divert is carried out on the base station (internal) (page 102),
the condition
On busy
is not available.
◆
All three conditions can be activated at the same time.
◆
If Night service has been set up for a receive MSN (page 85), external
call divert cannot be set up or changed for this receive MSN.