Swisscom Aton CL108, Руководство пользователя

Страница: 5 / 14

Aton CL108 / Swisscom EN / A31008-M2005-F151-1-2X19 / starting.fm / 23.07.2008
5
Placing the handset in the base station and registering
If you have purchased a model with multiple handsets , repeat the registration process
for each individual handset. Handsets are assigned the lowest available internal number
(1–4). If more than one handset is registered to the base station, the internal handset
number appears in the top left of the display, e.g. 2. If the internal numbers 1–4 are
already assigned to other devices, the number 4 will be overwritten.
Initial charging and discharging of the batteries
The correct charge level can only be displayed if the batteries are first fully charged and
discharged.
Please note
◆
Each key press interrupts the automatic registration.
◆
If automatic registration does not work, the handset will have to be registered
manually (
¢
p. 9).
◆ Only place the handset in the base station or charging cradle that is intended for
it.
V
Registering
V
INT MENU
Before you can use the phone, you must first register the
handset to the base station.
The handset registers automatically.
Registration can take up to 5 minutes .
Do not remove the handset from the
base station during this time.
After successful registration, the idle screen is displayed.
Charge status of the batteries:
–
= e V U
(flat to full)
–
=
flashes: batteries almost flat
–
e V U
flashes: charging
V
Put into base
MENU
¤
Place the handset with
the display facing up
in the base station.
¤
Place the handset in the base station or charging cradle for eight hours.
¤
Then remove the handset from the base station or charging cradle and
do not replace it until the batteries are completely discharged.
8 h