Swing-N-Slide PB 9210, Руководство по сборке

Страница: 16 / 68

16
PB 9210 Assembly Instructions
Swing Beam Drill Locations
1. Step 1: Tap t-nut into 3/8’’ hole as shown in (Fig. 7) .
2. Step 2: Place a bottom beam clamp over the swing hanger as shown in (Fig. 7) .
3. Step 3: Insert the swing hanger into the beam and thread it into the T-nut until it is flush or near flush with the
top of the T-nut. A screwdriver may be used to twist the hanger (Fig. 7) . Orient swing hanger as shown
in (Fig 7) .
4. Step 4: Use (4) 1-1/4'' screws to secure beam clamp.
5. Check hanger to ensure it does not spin.
6. Repeat for all swing hangers.
(4) 1-1/4'' screws
Swing Hanger
Use Screwdriver to aid in tightening
Bottom Beam Clamp
t-nut
Hammer
3/8'' hole
T-nut
Fig. 7