Swift Group Antibes 38x12-2 2020, Руководство пользователя

Страница: 52 / 110

53
Drain down procedure
1. Close hot and cold mains feed taps.
2. Remove the shower hose from the mixer or
lay the showerhead and hose in the shower
tray to drain off any trapped water.
3. Turn bottom tap valve fully open
4. Turn the top thermostat valve fully clockwise
to drain cold water, until water stops flowing.
5. Push in the red temperature set button
on the top thermostat valve and turn fully
anticlockwise to drain the hot water side
until the water stops flowing.
Protecting your Thermostatic Mixing Tap
In addition to draining down the Thermostatic
Mixer Tap in periods of cold and freezing
conditions, to offer maximum protection it is
highly recommended that the Thermostatic
Mixer Tap is further protected by following the
method outlined below:
First complete the drain down procedure
ensuring the hot and cold feeds are isolated
and fully drained.
Using an allen key, remove the mixer body from
the tails by releasing the grub screws taking
care not to misplace these.
The unit can then be completely drained, dried
and wrapped in a soft cloth for storage away
from frost until required.
The Thermostatic Mixer Tap can then be re-
attached as follows;
Re-fit body to the tails and tighten the grub
screws, take care not to over tighten.
Re-connect to the water supplies and check
seals.
i
Note: If after the drain down procedure
the Thermostatic Mixer Tap is to be left for
long periods in cold or freezing conditions,
leave the tap open and line up the ridge on
the thermostat hand wheel with the letter “H”
etched on the tap body.
Drain down procedure (fixed shower head)
1. Close hot and cold mains feeds using the
isolating valves.
2. Remove the shower hose (A) and drain the
hose and head or lay the hose and head
down in the shower tray to drain any excess
water.
3. Loosen the grub screw (C) to disconnect the
fixed head from the wall.
4. Loosen the two inlet nuts (B) at back of the
shower and disconnect the valve from the
wall.
5. Remove the whole unit from the wall, face
the inlet valves face down over the shower
tray until the water stops running.
6. Once the water is drained reverse the
process to reconnect the shower back to
the wall.
7. Let the water drain out of the valve into the
shower tray.
General Care