SPECIAL WAtEr
InnovAtIon
Anchor Buoy – Repair Instructions
4a: Push the end of the spring coil into the slot
of the hub.
4b: Secure the end of the spring coil with the
M4 set-screw with a 2mm Allen wrench.
5: Hold the spring coil tight against the hub
leading the spring in a clockwise direction
away from the slot in the hub.
6: Use a hammer to bend the spring coil so that
the end exits the slot in the hub and is in
close and even contact with the hub.
7: Hold the spring coil tightly and wind it
2 to 3 times around the hub.
note: observe the number of windings:
2 to 3 – no more and no less).
