©2022 SwellPro All Rights Reserved
38
1.
Place the drone on a level surface, power on the remote
controller then the drone. Wait for the aircraft to connect
to the remote controller.
2.
After the connection finishes, fast switch the Flight Mode
toggle back and forth until the aircraft's rear status
indicators flash green, or the remote controller screen
prompts "
Compass Calibration Rotate The Aircraft
Horizontally
". The drone will now perform compass
calibration.
3.
Pick up the aircraft and hold the drone horizontally and
rotate clockwise about 2~3 turns until the rear indicators
slowly flash green or the remote controller screen
prompts "
Compass Calibration Rotate Aircraft NOSE
DOWN
".
4.
Hold the drone nose-down and rotate clockwise about
2~3 turns until the remote controller screen prompts
"
Aircraft Initializing
，
Please Wait
".
5.
Place the drone on a level surface for 30 seconds. When
the prompt disappears, power off and restart the drone.
6.
The compass calibration is complete.
⚠
1) Compass calibration needs to be performed outdoors in an open area. 2) Remove
propellers before calibration. 3) Perform the calibration process away for sources of
magnetic fields, such as large metal structures, radio signal towers, power lines or
mobile phones, etc.
Gyroscope Calibration
The gyroscope provides stability data to the flight controller. If the gyroscope is not well
calibrated, the aircraft will tilt to one side when it takes off, and the tilted angle will
increase until the aircraft can no longer fly.
Process gyroscope calibration for the following situations:
•
The drone trembles significantly during hovering in GPS mode.
•
The drone's tilt range is too large during ascending in ATTI mode.
•
The drone drifts during ascending or descending in GPS mode.
•
The drone has been crashed or subjected to heavy shaking.
