Sweiss SKYTIG 2045 ACDC, Руководство оператора

Страница: 21 / 38

SWEISS
WELD.COM
info@sweissweld.com
NOTES
19
Indicate the welding voltage or other parameter.
Before the start of welding, the right-hand display shows the pre-set value of Tpr, Tup, Dcy, Fp, Tdown
andTpo. There is a 3s time-lag, open-circuit voltage is displayed after adjusting those parameters.
After the start of welding, the right-hand display shows the present actual value of the welding voltage.
(12) Welding current display
Display the pre-set or the actual welding current value.
Before the start of welding, the left-hand display shows the pre-set current value of Is, Iw, Ib and Ic.
After the start of welding, the left-hand display shows the present actual value of the welding current.
The control panel indicates which position has been reached in the welding process by brightening
the light.
NOTE:
Only “Parameter selection keys” and “Adjusting dial” can be used in the welding process.
Only “Rod electrode welding key”, “Adjusting dial” and “AC/DC selecting key” can be used on MMA
mode.
§4.3 Remote control
1-3 CURRENT SET They are factory set, can’t be changed. If they are changed, the welder may be
broken.
4 FACTORY TEST When it is ON, the welder is on debug state.
5 FOOT_REMOTE BOX SELECT When it is ON, the pedal control can be used When it is OFF, the
remote box can be used. Gun switch control current can be used both ON and OFF.
§4.3.1 Pedal switch control
●
When plug the fourteen-lead aero-socket of pedal switch in it. Welder will identify the pedal switch,
the welding current knob on the front panel will can’t use and only 2T can be selected.
●
When use the adjustment knob of max-welding current beside the pedal ,can set the max-
current you want.
●
The eighth and ninth of the fourteen-lead aero-socket is gun switch; The first and second of the