USER GUIDE
Ɩ
EM8500 SERIES
Copyright
2016, EM Microelectronic-Marin SA
EMDVK8500-MN01, Version 2.0, 5-Jul-16
10
420005-A01, 3.0
SW101 - MCU_RESET
Press button
to enter boot
D103 - MCU_STAT
Check that LED stop
blinking (boot mode)
J108 - MCU_BOOT
Place boot jumper for
for firmware update
1
2
3
Figure 4-1 Configure boot mode (firmware update)
Ɩ
The flash loader tool will guide you through the firmware download process.
It's not recommended to change the pre-configured settings. In case of errors, press the IPS Base Board RESET
button SW101 again (with the BOOT jumper placed) and navigate back to the communication selection tab and
retry.
Ɩ
After successfully downloading the new firmware click “Close” to exit the flash loader tool.
Ɩ
Remove the BOOT jumper and power-cycle the IPS Base Board.
