swaploader SL-214, Руководство по эксплуатации и частям

Страница: 70 / 106

Section IV: Maintenance
4.0.MAI.SL-214
MAST LOCK INSPECTION
The SL-214 hook-lift hoist comes with a mast lock (safety latch) assembly that is located on the
bottom side of the outer tube. When the jib is extended the mast lock then engages the cross
bar on the pivot joint, making the jib, outer tube, and pivot joint into a continuous member for
raising the container or body into a dump mode.
With the jib fully retracted the mast lock then disengages the latch bar on the pivot joint allowing
the hook-lift to enter the mount-dismount cycle by pivoting around the front pins of the pivot
joint.
INSPECTION
The mast lock assembly comes adjusted from the factory and should provide years of trouble-
free operation, however there may come a time when parts wear or become damaged and need
replaced. SwapLoader recommends that you regularly inspect all mast lock components for
damage or wear (see illustration below).
Inspect the safety latch (see illustration below); again, make sure the latch bar is not bent and
there is no missing hardware. Repair or replace any missing or bent components; refer to the
mast lock (safety latch) assembly drawing for proper part numbers and identification of the
components (See
Pg. 5-5 in the Parts Section of the manual). Proper engagement of the Pivot
Lock Prong under the Front Cross Bar is 3/4" to 1” when the jib is extended with 1/8” to 1/4" of
clearance.
4-4