5
Mounting the Camera
The camera can be mounted onto a flat surface using screws. The surface must have
sufficient strength to hold the camera. Materials such as hardwood, brick or masonry
are good options, and we’ve included all the gear you’ll need to mount it there (except
the tools - sorry, you’ll still need your own drill). You can mount the camera onto a metal
surface, but you’ll need to supply your own mounting hardware.
To mount the camera:
• Position the camera in the location you want to mount it, and mark the screw holes
on the surface to position the screws or attach the supplied mounting template on the
surface. Then, using appropriate screws for the surface you’re fixing the camera to,
secure the camera into place.
• If you’re mounting to a wooden surface, then screw the camera directly to the surface.
• If you’re mounting to a masonry surface (bricks, concrete or similar) then you’ll need
to use the included wall plugs.
Adjusting the Camera Angle
• Using the supplied L-wrench, loosen the appropriate hex screws on the stand to
pan, tilt or rotate the camera.
• Remember to tighten the screws back securely to lock the camera’s position in
place after you’ve finished adjusting the viewing angle of the camera.
Viewing the Camera on your Swann NVR
• After you’ve connected the camera to your Swann NVR, the camera will be
automatically detected and assigned an IP address when you turn on your NVR. If
the camera is not detected, check that the Ethernet cable is inserted correctly.
• Provided if all network connections have been correctly set up, the camera
should automatically appear on-screen shortly after being plugged in. Cameras
are assigned to the first available channel by your NVR in this case, irregardless
of which Network Camera port that it was connected to. You can still, however,
display the camera on a different channel. Please consult your NVR’s user manual
for an explanation on how to assign cameras to available channels.
Resetting the Camera
1. Unplug the Ethernet cable from the camera’s Network port, then press and hold
the Reset button and plug the Ethernet cable back into the camera’s Network port
(while still holding down the Reset button).
2. Release the button after a few seconds. The cameras settings will be reset to
factory default.
ENGLISH