AMI Codes-II
Program List and Explanations
A-96.250.571 / 050517
93
The relay will be switched via the Profibus input. No further param-
eters are needed.
This function is only available on relay 2. It is used to communicate
with canal switching instruments from third-party suppliers. The
relay closes for 1 sec. after each valid measurement. If End of
Batch is selected, no further selection is possible.
5.3.4
Input:
The functions of the relays and signal outputs can be de-
fined depending on the position of the input contact, i.e. no function,
closed or open.
5.3.4.1
Active:
Define when the input should be active:
5.3.4.2
Signal Outputs:
Select the operation mode of the signal outputs
when the relay is active:
5.3.4.3
Output/Control:
(relay or signal output):
5.3.2.1
Function = Fieldbus:
5.3.3.1
Function = End of Batch
No:
Input is never active.
When closed
Input is active if the input relay is closed
When open:
Input is active if the input relay is open
Cont.:
Signal outputs continue to issue the measured
value.
Hold:
Signal outputs issue the last valid measured value.
Measurement is interrupted. Errors, except fatal
errors, are not issued.
Off:
Set to 0 or 4 mA respectively. Errors, except fatal
errors, are not issued.
Cont.:
Controller continues normally.
Hold:
Controller continues on the last valid value.
Off:
Controller is switched off.
