AMI Codes-II CC
Program List and Explanations
A-96.250.581 / 220616
83
3.3 Simulation
To simulate a value or a relay state, select the
alarm relay,
relay 1 or 2
signal output 1 or 2
valve 1 or 2
with the [
] or [
] key.
Press the [Enter] key.
Change the value or state of the selected item with the [
] or
[
] key.
Press the [Enter] key.
The value is simulated by the relay/signal output.
At the absence of any key activities, the instrument will switch back
to normal mode after 20 min. If you quit the menu, all simulated val-
ues will be reset.
3.4 Set Time
Adjust date and time.
3.5 Cleaning
Automatic cleaning process using the Cleaning module-II con-
trolled by transmitter of AMI Codes-II CC.
Measurement is interrupted.
Flow error interrupts cleaning.
Cleaning does not start: E022 Reagent empty, E023 Cleaning
solution, no flow.
3.5.1
Parameter:
3.5.1.1
Mode
: Select daily, weekly or off.
3.5.1.xx
Start time/Calendar
: Time off day respectively weekday(s) for the
automatic start of the cleaning process.
Alarm Relay:
Active or inactive
Relay 1 & 2:
Active or inactive
Signal Output 1 & 2:
Actual current in mA
Signal Output 3:
Actual current in mA (if option is installed)
Valve 1 (photometer)
Active or inactive
Valve 2 (KI supply)
Active or inactive
