Removing the collected water
There are two ways to remove collected water.
1. Use the bucket
• When the bucket is full, the unit will automatically stop running,
and the Full indicator light will flash.
• Slowly pull out the bucket. Grip the left and right handles
securely and carefully pull out straight so water does not spill.
Do not put the bucket on the floor because the bottom of the
bucket is uneven. Otherwise the bucket will fall and cause the
water to spill.
• Throw away the water from the water outlet (See Fig.7) and
replace the bucket. The bucket must be in place and securely
seated for the dehumidifier to operate.
• The machine will re-start when the bucket is restored in its
correct position.
NOTES:
• When you remove the bucket, do not touch any parts inside of
the unit. Doing so may damage the product.
• Be sure to push the bucket gently all the way into the unit.
Banging the bucket against anything or failing to push it in
securely may cause the unit not to operate.
2. Continuous draining
Water can be automatically emptied into a floor drain by
attaching the unit with a water hose (12mm) (not included).
• Remove the rubber plug from the back of the unit and store it
in a safe location.
• Insert the water hose into the unit from the drain outlet in the
back of the unit as shown in Fig.8. Attach the water hose to
the drain hose outlet of the unit. Make sure the connection of
the water hose and the drain hose outlet of the unit is tight
and do not let the water leak.
• Then lead the water hose to the floor drain or a suitable
drainage facility. The drainage facility should be lower than the
drain outlet of the unit.
• Be sure to run the water hose sloping downward and let the
water to flow out smoothly. Do not install the water hose as
shown Fig.9a and Fig.9b.
NOTE:
When the continuous drain feature is not being used, remove
the drain hose from the outlet and attach the rubber plug
back to the drain outlet.
