www.swstahl.de
SW-Stahl GmbH
An der Hasenjagd 3
D-42897 Remscheid
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-Mail: [email protected]
B
E
D
IE
U
N
U
N
G
S
A
N
L
E
IT
U
N
G
/
IN
S
T
R
U
C
T
IO
N
M
A
N
U
A
L
72335L
Manual instruction:
1. Press the ON button until "0.00 BAR" or "0.00 PSI" appears in the display.
Shortly thereafter, a beep sounds, the device is ready for use.
By pressing the ON button again, you can move between the units of measure
BAR and PSI change.
2. Firmly press the nozzle of the digital tire air pressure tester onto the
tire valve. Take care that no air escapes from the tire.
3. As soon as a beep sounds, remove the device from the valve.
4. Now read the air pressure in the display.
5. For renewed measurements, please proceed as described in 2.
The device will turn off automatically after 90 seconds. By holding the ON button
(about 5 seconds) you can switch off the device manually.
Note:
- Measure the air pressure regularly. A correctly set air pressure saves
fuel and reduces tire wear.
- Measure the air pressure before driving.
- Follow the tire manufacturer recommendings for cold, unmarked tires
pressure ranges.
- The electronics module and the power cell are installed and sealed by the factory. The
device is maintenance-free
- If necessary, clean the device with a slightly moistened cloth.
- Do not use any other cleaning or abrasives.
- Do not immerse the digital tire compressor in water or other
Liquids
