SVS-Vistek CameraLink svs11002, Руководство пользователя

Страница: 41 / 47

Users Manual Area Scan Cameras svs11002 and svs16000 Page 41
Appendix C: Code Description for serial Camera Control
This description is useful for those who need to integrate the camera control into an application
and who cannot make use of the
Convenient Cam program.
1. Hardware
All commands to configure the camera are made using the serial CameraLink interface.
2. Protocol
Baudrate: 9600,
8 Databit, 1 Stopbit, no parity, no Handshake
When camera is powered on the following message will be displayed:
“KAI 11002 (or other sensor resp.) < 0 x 0 d, 0 x 0 a>”
3. Commands
The ENTER command can be activated either by “0 x 0 d, 0 x 0 a“ or by single “0 x 0 a“.
Valid tap numbers (Channelnumbers) are 1 or 2.
If correct the camera will respond with: “OK < 0 x 0 d, 0 x 0 a>“.
If not correct it will respond “Error<0 x 0 d, 0 x 0 a>“.
All numbers must by typed as hexadecimal values (hexvalues).
The command strings are case sensitive.
4.1 Accessible commands for the end user:
“C<ENTER>“: Output of camera status, e.g.:
KAI11000 ; Sensor Type
Gain1: 00AE ; gain tap 1
Gain2: 00A9 ; gain tap 2
Offset1 000A ; offset value tap1
Offset2: 0008 ; offset value tap2
CamMode: 0000 ; operation mode
Expocounter: 0400 ; exposure time
ControlReg2: 0002 ; ADC configuration, not changeable by user
ControlReg1: 0184 ; ADC configuration, not changeable by user
BlackCount: 000A ; ADC configuration, not changeable by user
CDSDelayReg: 0036 ; ADC configuration, not changeable by user
ADCDelayReg: 0000 ; ADC configuration, not changeable by user
SubstratV: 0038 ; Substrat voltage, not changeable by user
DumpCount: 0000 ; dump count for partial scan
Frames/s: 0010 ; Framerate
Lines/s: 804E ; Linerate
OK