ENG
Operation Manual
MS-2070
7
•
To auto scan and memorize the found stations, press button
f
on the front panel or the AUTO
o
button on the remote control long
. To stop auto scanning, press this button again before the
scanning is over. The display
a
will show the frequency being scanned. When the channel is being
memorized, the display shows its number for a short moment.
•
For manual scanning, use buttons TUN -/+
l
on the remote control (up/down the frequency
range). To save the selected station, press SAVE
c
button on the remote control and then buttons
n
on the remote control, assign the station its number and press SAVE button again.
•
If preset stations are available in the memory, you can switch from one to another by short pressing
buttons
c
,
d
on the front panel or buttons
n
on the remote control. You can also enter the
frequency or the number of the preset station with the remote control numeric pad buttons
p
. The
display
a
will show the station number for a short moment and then its frequency. The radio will tune
to the set frequency within 2-3 seconds.
AUX Mode
•
To switch to the AUX mode, press the MODE
b
button on the front panel or button
f
on the
remote control, the MSS switched on. The display
a
will show AUX.
ST-BY Mode
•
To enter/exit this mode, press and hold button
b
on the front panel or button
a
on the RC.
MUTE Mode
•
To enter the MUTE mode, press button
b
on the remote control. To exit the MUTE mode, press
button
b
again.
Note. Due to the constant development of the software, the actual MSS operation may differ
from that described in this Manual. The most recent version of the Manual is available at
www.sven.fi.
Fig. 5. Audio sources connection diagram
PC
Mobile device
2RCA to mini-jack
signal cable
Power
cord
