Svantek SV 200A, Руководство пользователя

Страница: 25 / 198

25 SV 200A User Manual
2.5 A
NTI
-
THEFT PROTECTION
There is a special swivel eye in the kit that can be used as anti-
theft protection of your SV 200A with the use of locking cable.
It is necessary to screw it to the base of the sleeve with the
special key.
2.6 W
INDSCREEN PROTECTION
The SA 209 foam reduces the effect of wind on measurement results.
Note: The windscreen influences the free-field characteristics of the instrument, therefore it is
important to check its condition regularly. In the case of visible degradation of the foam surface it
must be replaced by the new one.
During continuous usage, the SA 209 foam is exposed to different weather conditions with possibility of
causing mechanical damage to the foam’s structure. Therefore, it is recommended, at least once a quarter
(3 months), to check the condition of the foam by examining the surface for cracks by squeezing the foam.
If cracks or holes are observed, the
SA 209 foam must be replaced.
The SA 209 foam must be replaced whenever squeezing it causes severing of small pieces of its surface.
Replacement of the foam windscreen should be performed according to steps 1 to 5 of Chapter 4.1 and
steps 8 to 12 of Chapter 2.3 .
2.7 P
OWER SUPPLY UNIT
SB 274 is a waterproof single output switching power supply
which is characterised by:
•
Universal AC input / Full range (100 ~ 240 V AC)
•
Rated power 40 W
•
Built-in active PFC function
•
Class 2 power unit
•
Protections: Short circuit / Over load / Over voltage / Over
temperature
•
Fully encapsulated with IP67 waterproof level
•
Lemo 1B.303 connector
It is recommended to install the SB 274 power supply unit on a
mast, using 2 steel clamps and in the place not exposed to direct
sun light.
Note: See also SB 274 User Manual.
Note: Even though the power supply has a high IP index (Ingress Protection), it is still not
recommended to leave it on the ground for safety reasons. Good practice is to mount it on the
pole or mast.