Chevrolet Corvette Owner Manual (Holden-Localizing-Australia/New Zealand-
15749882) - 2022 - CRC - 9/20/21
88
Lighting
This indicator light turns on in the
instrument cluster when the high-beam
headlamps are on.
Headlamp Flash
To use the flash-to-pass feature, briefly pull
the turn signal lever toward you. The
high-beam indicator flashes to indicate to
the other driver that you intend to pass.
Daytime Running Lamps (DRL)
DRL can make it easier for others to see the
front of your vehicle during the day.
The DRL system makes the dedicated lamps
come on when the following conditions
are met:
.
The ignition is on.
.
The exterior lamp control is in the AUTO.
.
The light sensor determines it is daytime.
When DRL are on, only the front lamps will
be on. The park lamps, taillamps, instrument
panel lights, or other exterior lamps will not
be on when the DRL are being used.
When it is dark enough outside, the front
lamps dim to park lamps and the normal
low-beam headlamps turn on.
The regular headlamp system should be
turned on when needed.
To turn off the DRL, turn the exterior lamp
control to
;
. The DRL will stay off until
the control is toggled again.
Automatic Headlamp System
When the exterior lamp control is set to
AUTO and it is dark enough outside, the
headlamps and park lamps come on
automatically.
There is a light sensor on top of the
instrument panel. Do not cover the sensor;
otherwise the headlamps will come on when
they are not needed.
The system may also turn on the headlamps
and park lamps when driving through a
parking garage or tunnel.
If the vehicle is started in a dark garage, the
automatic headlamp system comes on
immediately. If it is light outside when the
vehicle leaves the garage, there is a slight
delay before the automatic headlamp
system changes to the DRL. During that
delay, the instrument cluster may not be as
bright as usual. Make sure the instrument
panel brightness control is in the full bright
position. See
When it is bright enough outside, the
headlamps and park lamps will turn off or
may change to Daytime Running
Lamps (DRL).
The automatic headlamp system turns off
when the exterior lamp control is turned to
O
or the ignition is off.
To turn automatic headlamp system back
on, turn the band to
O
again, then
release it.
If the automatic headlamp system has the
headlamps turned on and you turn the
ignition off, the headlamps will turn off.
When the driver door is opened the
headlamps and park lamps will illuminate
for a period of time.