Chevrolet Corvette Owner Manual (Holden-Localizing-Australia/New Zealand-
15749882) - 2022 - CRC - 9/20/21
Vehicle Care
219
Although the circuit is protected from
electrical overload, overload due to heavy
snow or ice may cause wiper linkage
damage. Always clear ice and heavy snow
from the windscreen before using the
windscreen wipers.
If the overload is caused by an electrical
problem and not snow or ice, be sure to get
it fixed.
Fuses and Circuit Breakers
The wiring circuits in the vehicle are
protected from short circuits by fuses. This
greatly reduces the chance of damage
caused by electrical problems.
{
Danger
Fuses and circuit breakers are marked
with their ampere rating. Do not exceed
the specified amperage rating when
replacing fuses and circuit breakers. Use
of an oversized fuse or circuit breaker can
result in a vehicle fire. You and others
could be seriously injured or killed.
{
Warning
Installation or use of fuses that do not
meet GM's original fuse specifications is
dangerous. The fuses could fail, and result
in a fire. You or others could be injured
or killed, and the vehicle could be
damaged.
See
and
.
To check a blown fuse, see
Instrument Panel Fuse Block
The instrument panel fuse block is behind
the glovebox. The glovebox can be accessed
by unlatching the door damper and
squeezing the pivot to release the damper
ring. Pull the glovebox bin side walls in to
release the door stops. Then turn the door
until the hinge hooks release from
hinge pin.
To Access:
1. Open the top cover.
2. Remove the top cover by pushing inward
on the latch.
3. Pull the cover upward.
To Install:
1. Insert the tabs on the back of the cover
into the slots in the instrument panel.
2. Align the clip with the slots in the
instrument panel.
3. Press the cover into place.
See your dealer if additional assistance is
needed.