Suzuki VLR1800, Руководство по обслуживанию

Страница: 431 / 624

Rear Suspension: 2C-10
2) Apply grease to the bearings.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
3) Install the cushion lever. Refer to “Swingarm /
Cushion Lever Removal and Installation (Page 2C-
5)”.
Swingarm Related Parts Inspection
B822H12306012
Refer to “Swingarm / Cushion Lever Removal and
Installation (Page 2C-5)”.
Spacers
1) Remove the spacers from the frame.
2) Inspect the spacers for wear and damage. If any
defects are found, replace the spacers with new
ones.
Swingarm Bearing
1) Insert the spacers into bearings.
2) Check the play by moving the spacers up and down.
If excessive play is noted, replace the bearing with a
new one. Refer to “Swingarm Bearing Removal and
Installation (Page 2C-11)”.
Swingarm
Inspect the swingarm for damage. If any defect is found,
replace the swingarm with a new one.
Swingarm Pivot Shaft
Measure the swingarm pivot shaft runout using the dial
gauge. If the runout exceeds the service limit, replace
the pivot shaft.
Special tool
(A): 09900–20607 (Dial gauge (1/100 mm, 10
mm))
(B): 09900–20701 (Magnetic stand)
(C): 09900–21304 (V-block (100 mm))
Swingarm pivot shaft runout
Service limit: 0.3 mm (0.01 in)
I822H1230020-01
I822H1230031-01
I822H1230032-01
I822H1230033-01
(A)
(B)
(C)
I649G1230034-03