Suzuki VLR1800, Руководство по обслуживанию

Страница: 148 / 624

1A-79 Engine General Information and Diagnosis:
1 5) If OK, then check the continuity between each terminal
and ground.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Injector continuity
∞ Ω
(Infinity)
Are the resistance and continuity OK?
Go to Step 2. Replace the injector
with a new one. Refer to
“Throttle Body
Disassembly and
Assembly in Section 1D
(Page 1D-12)”.
2 1) Turn the ignition switch ON.
2) Measure the injector voltage between the Y/R wire and
ground.
NOTE
Injector voltage can be detected only for 3
seconds after ignition switch is turned ON.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Voltage (
)
Injector voltage
Battery voltage
((+) terminal: Y/R – (–) terminal: Ground)
Is the voltage OK?
• Gr/W wire open or
shorted to ground, or
poor “48” connection
(#1 cylinder side).
• Gr/B wire open or
shorted to ground, or
poor “47” connection
(#2 cylinder side).
• If wire and
connection are OK,
intermittent trouble or
faulty ECM.
• Recheck each
terminal and wire
harness for open
circuit and poor
connection.
• Replace the ECM
with a known good
one, and inspect it
again. Refer to “ECM
Removal and
Installation in Section
1C (Page 1C-1)”.
Open circuit in the Y/R
wire.
Step Action Yes No
(A)
I822H1110079-01
(A)
I822H1110080-01