Suzuki TU250X, Руководство по обслуживанию, Страница: 208 / 370

FUEL SYSTEM AND THROTTLE BODY 5-15
THROTTLE BODY REASSEMBLY
Reassemble the throttle body in the reverse order of disassem-
bly. Pay attention to the following points:
• With the secondary throttle valve fully opened, install the STP
sensor
1
and tighten the STP sensor mounting screw to the
specified torque.
NOTE:
* Apply thin coat of engine oil to the O-ring.
* Align the secondary throttle shaft end
A
with the groove
B
of
STP sensor.
* Apply grease to the secondary throttle shaft end
A
if neces-
sary.

99000-25010: SUZUKI SUPER GREASE “A”
or equivalent

STP sensor mounting screw:
3.5 N·m (0.35 kgf-m, 2.5 lbf-ft)

09930-11950: Torx wrench (5 mm)
NOTE:
* Make sure the secondary throttle valve smoothly open and
close.
* If the STP sensor adjustment is necessary, refer to page 5-18
for STP sensor setting procedure.
• With the throttle valve fully closed, install the TP sensor
2
and tighten the TP sensor mounting screw to the specified
torque.
NOTE:
* Apply thin coat of engine oil to the O-ring.
* Align the throttle shaft end
C
with the groove
D
of TP sensor.
* Apply grease to the throttle shaft end
C
if necessary.

99000-25010: SUZUKI SUPER GREASE “A”
or equivalent

TP sensor mounting screw:
3.5 N·m (0.35 kgf-m, 2.5 lbf-ft)

09930-11950: Torx wrench (5 mm)
NOTE:
* Make sure the throttle valve smoothly open and close.

After installed TP sensor, adjust the TP sensor and
perform the TP learned value reset with SDS tool.
(

4-40, -69)