Suzuki SWIFT RS415 2017, Руководство по обслуживанию

Страница: 962 / 1257

8B-92 Air Bag System:
DTC Troubleshooting
Step Action Yes No
1 1) Disconnect side-sensor connector “L11” or “L35”.
2) Disconnect SDM connector “L29”.
3) Check proper connection to SDM connector at terminals
“L29-45” and “L29-46” or terminals “L29-43” and “L29-
44”.
4) Check proper connection to side-sensor connector at
terminals “L11-1” and “L11-2” or terminals “L35-1” and
“35-2”.
5) Using service wire (1), connect “L11-1” terminal and
“L11-2” terminal of driver side-sensor connector or “L35-
1” terminal and “L35-2” terminal of passenger side-
sensor connector.
6) Measure resistance between terminals “L29-45” and
“L29-46” or between “L29-43” and “L29-44” of SDM
connector.
Special tool
(A): 09932–76010
Is each measured resistance 1
:
or less?
Go to Step 2. DTC B1084: High
resistance or open wire
in “GRN/WHT” circuit or
“GRN/BLK” circuit.
DTC B1094: High
resistance or open wire
in “GRN/YEL” circuit or
“GRN/ORN” circuit.
2 1) Disconnect service wire from “L11” or “L35” connector.
2) Measure voltage between “L29-45” terminal and body
ground, “L29-46” terminal and body ground or “L29-43”
terminal and body ground, “L29-44” terminal and body
ground.
With ignition switch ON, is each measured value 1 V or less?
Go to Step 3. DTC B1084: “GRN/
WHT” circuit or “GRN/
BLK” circuit shorted to
power supply circuit.
DTC B1094: “GRN/
YEL” circuit or “GRN/
ORN” circuit shorted to
power supply circuit.
3 1) Check side-sensor referring to “Side-Sensor Inspection:
”.
Is it in good condition?
Substitute a known-
good SDM and recheck. Replace side-sensor
referring to “Side-
Sensor Removal and
Installation: ”. If DTC still
exists, substitute a
known-good SDM and
recheck.
(A)
"L11-1, L35-1" "L11-2, L35-2"
1
"L29-44" "L29-45" "L29-46" "L29-43"
I4RS0A820043-
(A)
"L29-44""L29-45""L29-46" "L29-43"
I4RS0A820044-