Suzuki SWIFT RS415 2017, Руководство по обслуживанию

Страница: 471 / 1257

Brake Control System and Diagnosis: 4A-4
Brakes Symptom Diagnosis
S4RS0A4104002
Condition Possible cause Correction / Reference Item
Not enough braking force Brake oil leakage from brake lines Locate leaking point and repair.
Brake disc or pads stained with oil Clean or replace.
Overheated brakes Determine cause and repair.
Poor contact of shoes on brake drum Repair for proper contact.
Brake shoes linings stained with oil or
wet with water Replace.
Badly worn brake pad linings Replace.
Defective wheel cylinders Repair or replace.
Malfunctioning caliper assembly Repair or replace.
Air in system Bleed system.
Maladjusted sensor spring length of
LSPV, if equipped Check or adjust.
Broken sensor spring of LSPV, if
equipped Replace.
Defective LSPV, if equipped Replace.
Malfunctioning ABS (Antilock brake
system), if equipped Check system and replace as necessary.
Brake pull (Brakes not
working in unison) Pad linings and/or shoe linings are wet
with water or stained with oil in some
brakes Replace.
Drum-to-shoe clearance out of
adjustment in some brakes
(Malfunctioning auto adjusting
mechanism) Check for inoperative auto adjusting
mechanism.
Disc and/or drum is out of round in some
brakes Replace.
Tires are inflated unequally Inflate equally.
Malfunction in wheel cylinders Repair or replace.
Disturbed front wheel alignment Adjust as prescribed.
Unmatched tires on same axle Tires with approximately the same amount of
tread should be used on the same axle.
Restricted brake pipes or hoses Check for soft hoses and damaged lines.
Replace with new hoses and new double-
walled steel brake tubing.
Malfunctioning caliper assembly Caliper should slide.
Check for stuck or sluggish pistons and proper
lubrication of caliper slide pin.
Loose suspension parts Check all suspension mountings.
Loose calipers Check and torque bolts to specifications.
Noise (high pitched
squeak without brake
applied) Front lining worn out Replace linings.
Contact wear indicator to brake disc Replace pads.
Rear brake locked
prematurely Maladjusted sensor spring length of
LSPV, if equipped Check or adjust.
Malfunction LSPV assembly, if equipped Replace assembly.
Excessive pedal travel
(Pedal stroke too large) Partial brake system failure Check brake systems and repair as necessary.
Insufficient fluid in master cylinder
reservoirs Check warning light. Bleed system if required.
Check for leaks and air in brake system.
Fill reservoirs with approved brake fluid.
Air in system (soft / spongy pedal) Bleed system.
Rear brake system not adjusted
(malfunctioning auto adjusting
mechanism) Adjust rear brakes.
Repair auto adjusting mechanism.
Bent brake shoes Replace brake shoes.
Worn rear brake shoes Replace brake shoes.
Brake locked (For vehicle
equipped with ABS) Malfunctioning ABS Check system referring to “ABS Check: in
Section 4E”.