Suzuki RM-Z250, Руководство по обслуживанию

Страница: 41 / 411

PERIODIC MAINTENANCE 2-25
VALVE CLEARANCE
• Remove the seat. (

5-2)
• Remove the radiator covers and fuel tank. (

13-2, -3)
• Remove the spark plug. (

2-7)
• Remove the cylinder head cover
2
and gasket
3
by remov-
ing their bolts
1
.
The valve clearance specification is different for both intake and
exhaust valves.
Valve clearance adjustment must be checked and adjusted: 1)
at the time of periodic maintenance, 2) when the valve mecha-
nism is serviced, and 3) when the camshafts are removed for
servicing.
NOTE:
* The piston must be at top dead center (TDC) on the compres-
sion stroke in order to check or adjust the valve clearance.
* The valve clearance should only be checked when the engine
is cold.
• Drain engine oil. (

2-13)
• Remove the TDC plug
4
and crankshaft hole plug
5
.
• Place a wrench over the crankshaft and turn it counter-clock-
wise to align the TDC mark
A
with the center of the groove
B
of the timing inspection hole.
• Insert the thickness gauge between the tappet and cam. If the
clearance is out of specification, adjust it to specification as
follows.

09900-20803: Thickness gauge

Valve clearance (when cold):
Standard: IN. : 0.09 – 0.16 mm (0.004 – 0.006 in)
EX. : 0.17 – 0.24 mm (0.007 – 0.009 in)