FI SYSTEM DIAGNOSIS 12-63
• Apply engine coolant to the O-ring
3
.
• Tighten the ECT sensor to the specified torque.
ECT sensor: 12 N·m (1.2 kgf-m, 8.5 lbf-ft)
• Connect the ECT sensor coupler.
• Pour engine coolant. (
14-3)
IAT SENSOR INSPECTION
The IAT sensor is installed on the air cleaner. (
12-44)
IAT SENSOR REMOVAL AND INSTALLATION
• Remove the seat and fuel tank rubber hand. (
5-2, 13-2)
• Disconnect the IAT sensor coupler
1
.
• Disconnect the IAT sensor screw
2
.
• Remove the IAT sensor
3
from the air cleaner outlet tube.
• Install the IAT sensor in the reverse order of removal.
IAT sensor mounting screw:
1.3 N·m (0.13 kgf-m, 0.95 lbf-ft)
TO SENSOR INSPECTION
The TO sensor is installed on the frame bridge. (
12-48)
TO SENSOR REMOVAL AND INSTALLATION
• Remove the fuel tank. (
13-2, -3)
• Disconnect the TO sensor coupler
1
.
• Remove the TO sensor
2
.
• Install the TO sensor in the reverse order of removal.
NOTE:
When installing the TO sensor, the arrow mark
A
must be
pointed upward.
Replace the O-ring
3
with a new one.
Replace the O-ring
4
with a new one.
Содержание RM-Z250
