Suzuki LT-Z400, Руководство по обслуживанию

Страница: 273 / 492

Starting System: 1I-11
Starter Torque Limiter Inspection
B933H21906009
Inspect the starter torque limiter in the following
procedures:
CAUTION
!
• Do not attempt to disassemble the starter
torque limiter.
• The starter torque limiter is available only
as an assembly part.
1) Hold the starter torque limiter with the special tools
and vise as shown in the figure.
Special tool
(A): 09930–73170 (Starter torque limiter
holder)
(B): 09930–73180 (Starter torque limiter
socket)
2) Turn the starter torque limiter with a torque wrench
and check the slip torque. If the slip torque is not
within the specification, replace the starter torque
limiter with a new one.
Starter torque limiter slip torque
Standard: 30 – 55 N
⋅
m (3.0 – 5.5 kgf-m, 21.5 – 40.0
lb-ft)
Starter Clutch Related Parts Inspection
B933H21906010
Refer to “Starter Torque Limiter / Starter Clutch Removal
and Installation (Page 1I-8)”.
Starter clutch
1) Install the starter driven gear onto the starter clutch.
2) Turn the starter driven gear by hand to inspect the
starter clutch for smooth movement. The gear turns
in one direction only. If a large resistance is felt for
rotation, inspect the starter clutch or the starter
clutch contacting surface on the starter driven gear
for wear or damage.
If they are found to be damaged, replace the one
way clutch with a new one.
Starter driven gear bearing
Inspect the starter driven gear bearing for wear or
damage. If necessary, replace it with a new one.
Starter idle gear
Inspect the starter idle gear for wear or damage. If any
damage is found, replace it with a new one.
(A)
(B)
I933H1190037-01
I933H1190038-01
I933H1190039-01
I933H1190040-01
PartShark.com
877-999-5686