Suzuki Liana RH418, Дополнительное руководство по обслуживанию

Страница: 242 / 371

5A-16 Automatic Transmission/Transaxle:
DTC Check
S3RH0B5104006
Automatic transaxle DTC can be checked using any one
of the following 2 methods.
Reading DTC Using SUZUKI Scan Tool
1) Prepare SUZUKI scan tool.
2) WIth ignition switch OFF, connect it to data link
connector (DLC) (1) located on underside of
instrument panel at driver’s seat side.
Special tool
(A): SUZUKI scan tool
3) Turn ignition switch ON.
4) Read DTC according to instructions displayed on
SUZUKI scan tool and print it down. Refer to
SUZUKI scan tool operator’s manual for further
details. If communication between scan tool and
TCM is not possible, check if scan tool is
communicable by connecting it to TCM in another
vehicle. If communication is possible in this case,
scan tool is in good condition. Then check data link
connector and serial data line (circuit) in the vehicle
with which communication was not possible.
5) After completing the check, turn ignition switch OFF
and disconnect SUZUKI scan tool from data link
connector (DLC) (1).
Displaying DTC on Odometer
1) Turn ignition switch OFF.
2) Remove glove box (1) from instrument panel.
3) Using service wire, connect diagnosis switch
terminal (3) with ground terminal (4) of blue monitor
connector (2).
4) Turn ignition switch ON.
5) Match the display to odometer.
6) Press reset button (5) and hold on pressing it.
7) Read DTC displayed on odometer (6). For example,
DTC No. 24 is displayed on odometer in the figure.
8) After completing the check, release reset switch, turn
ignition switch OFF and disconnect service wire from
monitor connector (2).
(A)
2
I3RH0A510010-01
5
3
4
2
1
6
7
I3RH0B510017-01