Suzuki K6A-YH6, Техническое руководство по ремонту, Страница: 77 / 113

REPAIR
7-23
7
Figure 7-58
IMPORTANT
Be sure camshaft housings are properly located.
Be sure dowel pins are properly aligned before
installing camshaft housings.
3. Check that the camshaft housing markings (3, 4, and
6) are located properly.
• The “I” or “E” markings (3) refer to intake or exhaust
side camshaft.
• The numerical markings (4) refer to the cylinder the
housing corresponds with. The cylinders are
numbered 1—3, starting from the timing chain
moving toward the rear of engine.
• The arrow marking (6) points toward the timing chain
(front of engine).
4. Apply engine oil to cap screws and hand tighten the
camshaft housings (5) to the cylinder head.
Figure 7-59
5. Tighten camshaft housings, using sequence
(1 through 11) at increments of 32 lb-in. (3.6 N•m)
until specification is reached.
Camshaft Housing Torque: 97 lb-in. (11 N•m)
6. Check valve clearance. (See “Valve Clearance Check
and Adjustment” on page 5-3.)
7. Install timing chain. (See “Timing Chain” on
page 7-14.)
8. Install front cover. (See “Front Cover” on page 7-12.)
9. Install oil pan. (See “Oil Pan” on page 7-30.)
10. Install idler pulley. (See “Idler Pulley” on page 7-38.)
11. Install crankshaft pulley. (See “Crankshaft Pulley” on
page 7-37.)
12. Install cam cover. (See “Cam Cover” on page 7-17.)
13. Install PCV valve. (See “PCV Valve” on page 7-4.)
14. Install spark plugs. (See “Spark Plugs” on page 7-8.)
15. Install ignition coils. (See “Ignition Coils” on
page 7-8.)
TN0416
4
5
6
3
TN0409
11
10
9
8
7
6
5
4
3
2
1