Suzuki Intruder VZ1500, Руководство по обслуживанию

Страница: 544 / 580

9A-5 Wiring Systems:
Wiring Harness Routing Diagram
B940H29102002
2
6
7
8
8
6
“D”
9
10
“C”
8
1
“A”
“B”
4
5
11
3
6
6
“ b ”
“ d ”
“ b ”
“ c ”
“ e ”
“ a ”
8
I940H1910907-08
1. Clamp
: Bind the handlebar switch (L) lead wire and clutch cable with the clamp. Cut the
tip of clamp after clamping.
11. Clamp
: Bind the HO2 sensor lead wire with the clamp.
2. Clamp
: Bind the handlebar switch (R) lead wire and brake hose with the clamp. Cut the
tip of clamp after clamping.
“A”: Pass the handlebar switch (R) lead wire in front of the guide.
3. Clamp
: Bind the wiring harness with the clamp.
“B”: Pass the handlebar switch (L) lead wire in front of the guide.
4. Clamp
: Bind the handlebar switch harness (L & R) and wiring harness with the clamp.
“C”: Pass the wiring harness inside of the seat lock cable.
5. Clamp
: Bind the handlebar switch harness (L & R) with the clamp.
“D”: Set the coupler between fuel feed hose and air cleaner tube.
6. Clamp “a”: 15 – 25 mm (0.6 – 1.0 in)
7. Clamp
: Bind the GP switch lead wire, side stand switch lead wire and wiring harness
with the clamp.
“b”: 5 – 10 mm (0.2 – 0.4 in)
8. Clamp “c”: 130 – 140 mm (5.1 – 5.5 in)
9. Clamp
: Bind the rear brake light switch lead wire and starter motor lead wire with the
clamp.
“d”: 5 – 15 mm (0.2 – 0.6 in)
10. Clamp “e”: 10 – 20 mm (0.4 – 0.8 in)