Suzuki Intruder VZ1500, Руководство по обслуживанию

Страница: 500 / 580

5B-14 Manual Transmission:
6) Remove the gearshift cam plate bolt (12) and
gearshift cam plate (13).
7) Remove the gearshift cam stopper (14).
8) Remove the gearshift arm stopper (15).
Installation
Install the gearshift shaft and gearshift cam plate in the
reverse order of removal. Pay attention to the following
points:
CAUTION
!
The removed snap rings must be replaced
with the new ones.
• Apply a small quantity of thread lock to the gearshift
arm stopper (1) and tighten it to the specified torque.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
Tightening torque
Gearshift arm stopper (a): 19 N·m (1.9 kgf-m, 13.5
lbf-ft)
• Install the gearshift cam stopper (2), bolt (3), washer
(4) and return spring (5).
• Apply thread lock to the gearshift cam stopper bolt (3)
and tighten it to the specified torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
NOTE
Hook the return spring end “A” to the
stopper (2).
Tightening torque
Gearshift cam stopper bolt (b): 10 N·m (1.0 kgf-
m, 7.0 lbf-ft)
13
12
14
I940H1520053-02
15
I940H1520054-01
(a)
1
I940H1520055-01
2
3
4
5
I940H1520056-03
(b)
3
2
“A”
I940H1520057-03