Suzuki Intruder VZ1500, Руководство по обслуживанию

Страница: 230 / 580

1D-41 Engine Mechanical:
• Apply grease to the O-ring.
CAUTION
!
Use a new O-ring to prevent mixture air from
soaking through the joint.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
NOTE
Face the “UP” mark on the intake pipe to
upper.
Valve Clearance Inspection and Adjustment
B940H21406017
Refer to “Valve Clearance Inspection and Adjustment in
Section 0B (Page 0B-3)”.
Cylinder Head Cover Inspection
B940H21406018
Inspect the cylinder head cover in the following
procedures:
1) Remove the cylinder head covers. Refer to “Engine
Top Side Disassembly (Page 1D-27)”.
2) Clean and check the gasket grooves “A” and PAIR
reed valve gasket mating surfaces “B” of the cylinder
head cover.
If it is damaged, replace the cylinder head covers
with a new one.
3) Install the cylinder head covers. Refer to “Engine Top
Side Assembly (Page 1D-32)”.
Camshaft Inspection
B940H21406019
Refer to “Engine Top Side Disassembly (Page 1D-27)”.
Refer to “Engine Top Side Assembly (Page 1D-32)”.
Camshaft Identification
The camshafts can be identified by the engraved letter.
Cam Wear
Check the camshaft for wear or damage.
Measure the cam height “a” with a micrometer.
Replace a camshaft if the cams are worn to the service
limit.
Special tool
: 09900–20202 (Micrometer (1/100 mm, 25 – 50
mm))
Cam height “a”
Service limit: (IN.) 32.760 mm (1.2898 in)
Service limit: (EX.) 32.810 mm (1.2917 in)
I940H1140124-01
“A”
“B”
I940H1140125-02
“A”: Front camshaft “B”: Rear camshaft
“A”
“B”
I940H1140126-01
“a”
I649G1140199-02