Suzuki GSF650, Руководство по обслуживанию

Страница: 159 / 333

4-24 FUEL SYSTEM
REMOUNTING
Remount the carburetor assembly in the reverse order of removal. Pay attention to the following points.
CARBURETOR CLAMPS
Position the carburetor clamps as shown.
THROTTLE CABLE ADJUSTMENT (MAJOR ADJUSTMENT)
NOTE:
Minor adjustment can be made by the throttle grip side adjuster.
(

2-11)
• Remove the fuel tank. (

4-3)
• Loosen the locknut
1
of the throttle returning cable.
• Turn the returning cable adjuster
2
to obtain proper cable
play.
• Loosen the locknut
3
of the throttle pulling cable.
• Turn the pulling cable adjuster
4
in or out until the throttle
cable play
A
of 2.0 – 4.0 mm at the throttle grip is obtained.
• Tighten the locknut
3
securely while holding the adjuster
4
.
• While holding the throttle grip at the fully closed position,
slowly turn the returning cable adjuster
2
to obtain a cable
slack
B
of 1.0 mm.
• Tighten the locknut
1
securely.
• After all of the work has been completed, install the carburetor
assembly onto the engine and perform the following adjust-
ments.
* Engine idle speed .............................................

2-11
* Throttle cable play ............................................

2-11
* Carburetor synchronization ..............................

4-25
#2 #3 #4
LH RH
Carburetor clamp position (air cleaner side)
Carburetor clamp position (engine side)
#1
#2 #3 #4 #1
0 – 10˚