5-55 CHASSIS
• Remove the pillion footrest bracket lower bolt
4
, spacer
5
,
swingarm pivot nut
6
and washer
7
.
• Remove the right pillion footrest bracket
8
.
• Remove the rear brake pedal
9
.
INSTALLATION
Install the rear brake pedal in the reverse order of removal. Pay
attention to the following points:
• Apply SUZUKI SUPER GREASE “A” to the rear brake pedal
shaft.
*
99000-25010: SUZUKI SUPER GREASE “A”
• Install the right pillion footrest bracket
1
.
• Install the washer
2
, swingarm pivot nut
3
, spacer
4
and
right pillion footrest bracket lower bolt
5
.
• Tighten the swingarm pivot nut
3
and pillion footrest bracket
lower bolt
5
to the specified torque.
"
Swingarm pivot nut: 57.5 N·m (5.75 kgf·m)
Pillion footrest bracket lower bolt: 55 N·m (5.5 kgf·m)
• After installing, check the rear brake for operating condition,
play and braking effect.
• Check the brake light lighting timing.
Содержание FL125S
