Rev. 2.4
- 32 -
© 2014 Suzo-Happ Group
Bill-to-
Bill™ 300XE
5.3.
Recycling Cassettes (BBR-011X)
After an all round inspection is done to ensure no dents, scratches or cracks are present, the
recycling cassettes are first cleaned by following the same steps as in Level 1 maintenance.
Next, inside each cassette two white, parallel tapes are found. Using a soft blunt object, or ones
finger pad press down each tape in a location where no wheels or drums are present, press it up
1”
down. Some resistance should be felt. Then, by quickly removing the object or ones finger, one
should observe a spring-back effect of the tape (it should not remain loose)
If cuts or tears are found on the tape inside the cassette, contact a service center for
replacement immediately
Observe the two sensors located at the edge of the cover and edge of the opening on the
cassette. In order to ensure proper bill detection, ensure the sensors are flushed with the
surface as mentioned before.
Additionally, remove the side covers of the dispenser and remove the two plastic push rivets on the
two sides of the cassette as shown below to unlock the sensor array from its position.
