Rev. 2.4
- 23 -
© 2014 Suzo-Happ Group
Bill-to-
Bill™ 300XE
4.5. Dispenser (BBD-XXXX)
The dispenser must be thoroughly cleaned since it interfaces with the environment and is susceptible
to a substantial amount of dust and debris. There are three sets of sensors in the dispenser that must
be taken care of. The first two can be found by carefully opening the top cover. They are located at
the bottom floor of the dispenser. These sensors must be cleaned using a cotton swab.
Older models of dispenser may only have one sensor at the bottom.
The third sensor is located at the bill entrance (entrance of the bill from the path switch). It should be
cleaned using a new cotton swab
