Suzohapp ARPEGE SECURITY SC-350, Техническое руководство

Страница: 43 / 114

Set-up
Technical Handbook 019722-101 Rev. 05
33
SC-350/360
>>>
If there is a decimal point in the lower right hand corner of the
display, the service limit is reached.
Note! This function is only available in program version 4.00 and on.
The set-up of the service intervals can be protected by a password.
The display shows “SErm x“ to indicate that the service interval
information is accessible.
Example (default setting):
Note!
If a password is set, the display will show “P. - - -”. Enter the password
to continue. If the password is correct, the display will show “SEr x”.
If incorrect, the machine will return to normal operating mode.
3 - Number of coins counted
a) To display the number of coins counted since the last reset, press
M .
b) To zero the number of coins counted press M and C at the same
time. If the decimal point to the far left was flashing, the flashing
stops.
4 - Service interval
To display the number of coins, in millions, that are counted before
the machine is due for service press
Q
.
5 - Setting the service interval
a) Press and hold
Q
.
b) Select the required interval (in millions of coins) by pressing M ,
ACC , B and C .
c) Release Q when the required service interval is displayed.
Note!
The highest interval that can be set is 3,999 million (“3999” on the
display).
m Normal position m is blank, but a “d” will show in the
demonstration mode.
x x is the current service interval mode.
S m r E x