Sutter Lambda VF-5, Руководство по эксплуатации

Страница: 57 / 78

LAMBDA VF-5 OPERATION MANUAL – REV. 1.04A (20190606)
47
Figure 7-8 -- Browsing for the driver file needed.
Once the requested files are located, the Windows USB device installer will complete. Note
that you may need to cycle through the two dialogs shown in the last two figures before the
requested file is located and installed.
This completes the description for installing the Lambda VF-5 as a USB device connected to a
Windows system.
7.2 Installing the USB Interface for Non-Windows Systems
The Lambda VF-5 can be connected with the USB interface to computers that are not
running Windows. However, limited support and information is provided for them. For the
Linux and Macintosh operating systems, please visit the following web sites for more
information.
1.
Linux drivers and tools:
http://ftdi-usb-sio.sourceforge.net/
2. Apple Macintosh drivers, tools, and information:
http://www.ftdichip.com/FTMacDriver.htm
7.3 Verifying USB Communication between Remote Computer and Lambda VF-5
Once the Lambda VF-5 has been connected to the remote computer with the USB cable and
the remote computer has had the necessary device drivers installed, you will probably want
to test and verify that the remote computer is, in fact, communicating correctly with the
Lambda VF-5 over its USB connection. Probably the most expedient method for doing this
testing is to install and run on the remote computer the USB Test and Demo program for the
Lambda 10-series (a Windows program). This program is called “USBTest”, and once
installed, can be used to determine if the remote computer is able to communicate with the
Lambda VF-5 as a USB device. The USBTest program is provided on a 3.5-inch HD floppy