Sutter CURIS 36 0 00-01, Инструкция по эксплуатации

Страница: 13 / 48

CURIS
®
Instructions for Use
9
5 Commissioning
5.1 Validity of these instructions for use
These instructions for use are valid for all CURIS
®
devices with hardware and software according to
the hardware and software status (48) on the type plate equal to “0607”. The type plate is on the
rear of the device.
Pressing the “CUT 1” and “EXCISE” buttons while the device is powering up shows the software
version in the bottom two rows of the display: for example, 701 means V 7.01.
5.2 Potential equalization connection
Potential equalization is a connection of device housings with good electrical
conductivity. It is intended to ensure that the devices consistently maintain the
same electrical potential, even in case of an electrical defect. Potential
equalization is prescribed for certain operating rooms, for instance for
intercardial procedures, and can be established via the potential equalization
connection (46). The required connecting cable is not included in the scope of
delivery and can be obtained from us if needed.
5.3 Mains supply
WARNING
To exclude the risk of electric shock, this device may only be
connected to a mains network with protective conductor.
The device is equipped with a multi-voltage power supply. It can be operated in
the following voltage range without switching:
100 – 240 V AC, 50/60 Hz
The fuses are located on the rear of the device in the slot (44) on the mains
connection socket.
Connect the mains cable to the connection socket (45) on the rear of the device
and the other end of the mains cable to an outlet.
For the all-phase, full disconnection of the device in case of danger, either the
connection socket on the device or the outlet where the mains cable is plugged
in should be left accessible.
No special measures are required to take the device out of operation.
5.4 Turning the device on and off
Turn the device on and off using the power switch on the front (power switch (1)).
For the all-phase disconnection of the mains voltage, the mains cable has to be
unplugged.
O
I