Sutter Instrument P-97, Инструкции по эксплуатации

Страница: 39 / 66

29
Figure 3-11. Fire Polish Spacer in Puller Bar.
3.6 Heating Filaments
3.6.1 General Information
The pipette programs that you ultimately develop will largely depend on the type of heating
filament installed in the puller and the glass that you use. Depending on your research
application, there may be an optimum filament/glass combination that differs from the
configuration with which the puller is currently set up. After reading through the following
material, if you have questions about which filament to use for your application, contact our
technical support staff.
3.6.2 Filament Positioning and Aligning
Figure 3-12. Filament alignment.
Adjust the filament position using the two eccentric chrome screws located on the silver or
black angle piece that holds the filament assembly (A and B in Figure 3-1). First loosen the
two locking screws (A’ and B’ in Figure 3-1) and then the filament can be moved in relation
to the glass tubing by turning the appropriate eccentric chrome screw (A or B in Figure 3-1).
See the Filament Replacement section of the Maintenance Chapter for a full description of
this adjustment.
P-97 FLAMING/BROWN MICROPIPETTE PULLER OPERATION MANUAL – REV. 2.43 - DOM (20161118)