11
WARNING: DO NOT LOOK DIRECTLY INTO THE
LIGHT GUIDE! The output of the light or the light guide should be
directed into the microscope using the appropriate adapters, directed
away from anyone’s eyes, and not directed toward any reflective
surface.
2.3
Configuring Input and Output TTL Logic
Input and output TTL logic is configured using the first three switches of the four-switch
DIP bank located on the control board inside the controller cabinet. To access the DIP switch
bank, remove left-side panel (left-side while viewing the front panel) by unscrewing the six
screws.
Figure 2-2. Lambda HPX-series left-side panel removed for access to configuration DIP switches.
While viewing the left side of the cabinet, the location of the DIP switch bank on the
vertically-mounted control board as shown in the following figure.
LAMBDA HPX-L5 OPERATION MANUAL – REV. 1.03 (20161130)
Содержание Lambda HPX-L5
