Sutter Instrument Lambda 421, Руководство по эксплуатации

Страница: 13 / 42

LAMBDA 421 OPERATION MANUAL – REV. 1.00N (20170623)
5
2. INSTALLATION
2.1 Unpacking
The Lambda 421 and associated hardware comes packed in a single carton. The following is a
list of the components found there. If you believe that any of these components are missing
or show obvious signs of damage from shipping, please contact the factory.
„
Lambda 421 cabinet containing factory-installed power supply, control electronics, four
light source drivers, Optical Beam Combiner (OBC) mounted with up to four different
wavelength LED light sources, front-panel controls, and rear-panel external-control
connectors
„
The OBC’s four light source inputs has installed an LED module for the following
wavelength (nanometers): 340, 365, 380, 385, 410, 440, 460, 480, 506, 530, 561, 590, 630,
660, 740, 850, 940, or white light. Each channel’s optics (mirror & filter) are especially
installed and aligned according to the LED’s wavelength chosen.
„
Power Cord
„
Liquid Light Guide
„
Liquid Light Guide dovetail with C-mount extension
„
Small Zeiss female dovetail
„
USB Interface Cable
„
9-pin Serial Interface Cable
„
25-pin Parallel Interface Cable
„
Manual
„
One or more additional LED Assemblies containing different wavelength LEDs (if
ordered)
„
Microscope adapters (if ordered)
2.2 Installation Instructions
1.
Turn power switch to OFF (“0”) position.
2. Plug power cable into the mains outlet.
3. Connect the optical output directly to the microscope via the appropriate adapter or to a
liquid light guide, as appropriate.
4. Make sure that all of up to four light sources (LEDs or external) are connected to the
Optical Beam Combiner (OBC) inputs.
5. Ensure that that the right side switch for each channel (Channel 0 through 3) is in the
OFF position.
6. Power up the Lambda 421 rocking the power switch (far right side of the front panel)
upwards in “1” position. A red LED immediately to the left of the power switch will
illuminate when power is on.
7. Refer to the Operations chapter for instructions on turning on the Lambda 421 and
operating the controls on the front panel and making connections to the rear panel.